Huebsch Commercial Washer Troubleshooting
If your Huebsch commercial washing machine is giving you problems, don’t fret. Our guide can help you with the most common Huebsch commercial washer troubleshooting tips needed to get your unit back up and running like new. No matter if you have an ATZ90A*N1102 model or another front load washer, follow this guide to identify the issue and solution.
Huebsch Front Load Washer Won’t Fill
There could be a variety of things causing your washer not to fill properly. Before calling a technician, check these aspects of your unit:
- The cord isn’t plugged in
- The fuse blew
- The controls aren’t properly set
- START wasn’t fully pressed
- The loading door isn’t tightly closed
- The hot and cold faucets aren’t on
- There’s a kink in the fill hose
- The filter screens are filled with debris
Front Load Washer Won’t Start
If your Huebsch washer isn’t starting right or at all, check the following to see if one of these common issues is preventing your machine from working correctly:
- The cord isn’t plugged in
- The fuse blew
- The controls aren’t properly set
- START wasn’t fully pressed
- The loading door isn’t tightly closed
- A card or coin wasn’t inserted
- The door latch isn’t aligned to the door lock
Front Load Washer Won’t Spin/Tumble
Some of these issues are similar to those above. Double check any of these things to ensure your washer works properly:
- The cord isn’t plugged in
- The fuse blew
- The controls aren’t properly set
- START wasn’t fully pressed
- The loading door isn’t tightly closed
- The drive belt is broken
- There’s debris in the pump
Front Load Washer Stops/Pauses During a Cycle
Some pauses during a cycle are completely normal. If you notice an abnormal pause, check these things before calling a technician:
- A fuse has been blown
- The wash load is unbalanced
Front Load Washer Won’t Drain
While a lot of the draining issues will be with the hoses, there are a few other issues that can cause a draining problem:
- The drain hose is kinked or twisted
- The drain hose is clogged
- The drain receptacle is clogged
- The pump is clogged
- Check that the drain hose was properly installed
Additional Huebsch Commercial Washer Troubleshooting Tips
Here are some additional Huebsch commercial washer troubleshooting tips for some of the smaller issues that you may come across:
Water Leaks
- Check that the fill hoses are securely connected
- Check that the fill hoses don’t have holes or signs of wear
- Make sure the drain receptacle isn’t clogged
- Check the laundry room plumbing
- Check the rubber gaskets for tears
- Make sure you’re using low-sudsing detergent
- Make sure the laundry load isn’t too much
Too Many Soap Suds
- Laundry load may be oversudsing
- Make sure you’re using the correct detergent
- Laundry machine may be overloaded
Vibrates/Moves Slightly
- Make sure the washer is level
- Make sure all of the rubber feet are installed on all four legs
Too Noisy
- Make sure the washer is level
Load Comes Out Too Wet
- Washer load may be unbalanced
- Load is too small
Wrong Water Temperature
- Make sure the temperature settings are correctly set
- Check the fill hoses
- Make sure the laundry room water heater is adjusted properly