Electrolux Dishwasher Error Codes
An Electrolux dishwasher is a vital appliance in your home. Not only does it make dishwashing quick and simple, but it can help you save water and energy. That’s why it’s crucial to find the source of the problem should your dishwasher’s display show an error code. If you’re in this situation, take a look through our comprehensive guide on Electrolux dishwasher error codes and find a solution quickly.
This guide features general error codes that are applicable to most Electrolux dishwasher models, such as the EDSH4944AS and EDSH4944BS.
General Note
Pressing the cancel button or turning the power off at the breaker for 5 minutes should clear the error code, and the dishwasher can be restarted. If the code isn’t cleared after this, contact an authorized service technician.
User Code: CLOSE
Problem
The door has been left open or isn’t properly latched.
Solution
Make sure the door is closed and latched.
Error Code: i10 / E10
Problem
Dishwasher has been filled too low.
Solution
Check for a pinched water line. If the water line looks fine, the problem may be caused by the water shutoff not being fully open.
Error Code: i20, i40 or iF0 / E20, E40 OR EF0
Problem
Restricted drain lines or clogged filters.
Solutions
- Check both filters and clean if needed.
- Check for a blocked or pinched drain hose.
- Check that the knockout plug has been removed if the drain line is attached to a disposer.
Error Code: i30 / E30
Problem
A leak or overflow is in the bottom pan.
Solution
Check for loose connections at the water inlet valve, and make sure your dishwasher is properly leveled.
Error Code: i50 / E50
Problem
There’s an issue with the wash or drain motor.
Solution
Press the cancel button or turn the power off at the breaker for 5 minutes. This should clear the error code, and the dishwasher can be restarted. If the code isn’t cleared after this, contact an authorized service technician.
Error Code: i60 / E60
Problem
There’s an issue with the water heating system.
Solution
Press the cancel button or turn the power off at the breaker for 5 minutes. This should clear the error code, and the dishwasher can be restarted. If the code isn’t cleared after this, contact an authorized service technician.
Error Code: iC0 / EC0
Problem
There’s an issue with the electronic control system.
Solution
Press the cancel button or turn the power off at the breaker for 5 minutes. This should clear the error code, and the dishwasher can be restarted. If the code isn’t cleared after this, contact an authorized service technician.