Antunes Tortilla Warmer Error Codes
When machines have errors, it can stop productivity and really cause a problem in commercial kitchens. Luckily, we have the solutions you need to deal with any Antunes tortilla warmer error codes you might run into. From temperature errors to serious control board issues, we go over the most common codes, their problems and the solutions you need to get equipment back up and running.
The following fixes are applicable to the TW-100.
Error Codes
| Error Code | Problem | Solution |
2 - Zero Cross | Internal control board error | Power off, unplug and wait 30 seconds, then power back on. For further help, contact an authorized service agent |
| 5 - I2C Timeout | Control board hardware failure | Power cycle the unit. For further help, contact an authorized service agent |
6 - Memory | Memory chip error | Power off, unplug and wait 30 seconds, then power back on. For further help, contact an authorized service agent |
| 9 - Board Temperature | Internal air temperature too high, system powering down | Check for vent blockage and adequate spacing around vents. Be sure the unit has proper space around it. |
| 101 - Hi-Limit | Hi-limit is tripped | Wait 10-15 minutes for cool down. Remove hi-limit control cap. Press hi-limit reset. Turn on unit and test. For further help, contact an authorized service agent |
105 - Over Temp | Temperature on top platen is 25°F over set temperature | Power off, unplug and wait 30 seconds, then power back on. For further help, contact an authorized service agent |
106 - Over Temp | Temperature on bottom platen is 25°F over set temperature | Power off, unplug and wait 30 seconds, then power back on. For further help, contact an authorized service agent |
111 - Under Temp |
Top platen drops 100°F below set point temperature when in use | Power off, unplug and wait 30 seconds, then power back on. For further help, contact an authorized service agent |
112 - Under Temp |
Bottom platen drops 100°F below set point temperature when in use | Power off, unplug and wait 30 seconds, then power back on. For further help, contact an authorized service agent |
|
|
|
|
|
|
135 - Warmup Time | Top platen taking too long to warm up | Power off, unplug and wait 30 seconds, then power back on. For further help, contact an authorized service agent |
136 - Warmup Time | Bottom platen taking too long to warm up | Power off, unplug and wait 30 seconds, then power back on. For further help, contact an authorized service agent |
129 - Top Platen Solid State Relay | SSR shorted, wiring shorted or control board failed | Contact an authorized service agent to assist |
130 - Bottom Platen Solid State Relay | SSR shorted, wiring shorted or control board failed | Contact an authorized service agent to assist |
141 - Top Platen Open Heater | SSR open, wiring open, heater failure or control board failed | Contact an authorized service agent to assist |
142 - Bottom Platen Open Heater | SSR open, wiring open, heater failure or control board failed | Contact an authorized service agent to assist |